The core principles for preparing a remote-controlled lawn mower for long-term storage (generally referring to idle time exceeding 1 month) are cleaning and drying, power-off protection, and component maintenance. These steps prevent body rust, battery damage, and mechanical jamming. The specific procedures are as follows:

I. Thoroughly Clean the Body and Components

1. Clean the Cutter Head and Blades

• After powering off, remove the blades. Use a brush or a high-pressure water gun (low-pressure mode) to clear grass clippings, soil, and sap residues from the cutter head and blades, avoiding corrosion of metal parts caused by dried-on debris.

• Check the blade condition: For mild rust, polish with sandpaper to remove rust; if the wear is severe, replace the blades directly to prevent rust spread.

2. Clean the Body Shell and Chassis

• Wipe dust and oil stains off the body surface with a damp cloth. Focus on cleaning heat dissipation holes and sensor lenses (such as obstacle avoidance cameras and LiDAR) to prevent clogging or reduced sensitivity.

• Clear soil and gravel from the gaps of chassis rollers and tracks to avoid component deformation or rotation jamming due to long-term accumulation.

3. Air-Dry Moisture

• After cleaning, place the lawn mower in a well-ventilated, cool area to air-dry naturally. Do not expose it to direct sunlight. Ensure no residual moisture remains inside the body and battery compartment to prevent damp-induced short circuits.

II. Specialized Battery Maintenance (Core Step for Electric Models)

1. Control Storage Power Level

• Lithium batteries: Charge the battery to 50%–60% and then disconnect the power supply. This is the safe storage level for lithium batteries, which prevents cell failure caused by over-discharge and aging acceleration caused by full-charge storage.

• If the battery is detachable, it is recommended to remove it for separate storage; for non-detachable models, turn off the main power switch.

2. Select the Storage Environment

• Store the battery in a dry, cool, room-temperature (10℃–25℃) environment, away from heat sources (heaters, stoves), flammable and explosive materials, and metal conductors to avoid short circuits.

• For long-term storage (more than 3 months), recharge the battery every 1–2 months to maintain the power level at around 50%.

III. Lubrication and Protection of Mechanical Components

1. Lubricate Transmission and Travel Components

• Apply a small amount of special lubricating oil or grease to drive wheel bearings, track pins, cutter head rotating shafts, and other parts to prevent rust and jamming during long-term idleness.

• Note: Do not use excessive lubricant to avoid dust adsorption and secondary wear.

2. Rust Prevention for Corrosion-Prone Components

• Apply a thin layer of anti-rust oil to metal parts such as blades and bolts; if anti-rust oil is unavailable, a small amount of engine oil can be used as a substitute.

• Repair paint scratches on the metal body shell with a touch-up pen to prevent rust expansion.

IV. Storage Location and Protection Measures

1. Choose the Storage Location

• Priority should be given to indoor dry and ventilated areas, such as garages and storage rooms. If outdoor storage is unavoidable, cover the mower with a dedicated waterproof and dustproof protective cover to avoid rain, direct sunlight, and dust accumulation.

2. Body Placement Position

• Place the lawn mower horizontally to prevent lubricant accumulation or component deformation due to pressure from tilting. If the height adjustment function is available, keep the cutter head in a raised position to avoid blade contact with the ground and moisture absorption.

V. Storage of Control System and Accessories

1. Remote Control Maintenance

• Remove the battery from the remote control to prevent circuit board corrosion caused by battery leakage. Clean the remote control buttons and antenna, and store them in a dry packaging box.

2. Accessory Organization

• Store accessories such as chargers, spare blades, and wrenches separately from the lawn mower to avoid component extrusion or body scratches. Place the charger in a moisture-proof bag to prevent interface dampness.