I. Before Operation

• Clear the site: Remove stones, iron wires, branches and debris to prevent injury from flying objects.

• Check: Engine oil, gasoline, blades, screws, tracks/tires, brakes and remote control signal.

• Test run: Idle and run at low speed to ensure normal steering, lifting and emergency stop.

• Wear properly: Non-slip shoes, long pants and goggles; do not wear loose clothing.

II. During Operation

• Keep operator in safe area: Always stay 5 meters behind and to the side of the machine. Do not stand in front or on the slope.

• Keep away from cutter deck: Never approach the rotating cutter deck. Cleaning is only allowed after engine stops.

• Slow on slopes: Drive up and down slopes longitudinally, not crosswise; no sharp turns or overspeed.

• Do not exceed safe slope: Never work on slopes steeper than rated maximum.

• Keep remote control at hand: Stop immediately if signal is weak; no blind long-distance operation.

• Keep children and bystanders away: No people within working radius.

III. Special Situations

• Abnormal noise or vibration: Stop engine immediately and inspect; do not operate with faults.

• Blade winding: Stop engine, disconnect spark plug/power before cleaning.

• Stuck or slipping: Do not force forward; use tools for assistance. Do not stand beside tracks.

IV. After Operation

• Park on flat ground, stop engine and apply parking brake.

• Refuel, clean and maintain only after cooling down.

• Store remote control properly and lock the machine.

One-sentence safety summary:Clear first, test run, stand behind, keep away from cutter deck, drive longitudinally on slopes, stop if signal is weak.